Infusion™ Floor Sealer & Finish




Product Description
Infusion™ Penetrating Hardener is a revolutionary product that incorporates advances in micro technology with conventional floor finishes.

Infusion™ Penetrating Hardener is an impregnating formulation that is designed to penetrate into the existing floor seal and/or finish, chemically bond with it and physically change its properties when burnished. When Infusion™ Penetrating Hardener is applied to floor finish it changes the molecular structure of the finish into an exceptionally hard film. The results are an extremely durable finish that will resist attack from the toughest soils, yet is flexible enough to respond to high-speed and ultra high-speed burnishing.

By using Infusion™ Penetrating Hardener you can burnish the floor multiple times before additional product is required.
Infusion™ Penetrating Hardener has been tested and certified by the National Floor Safety Institute.

Directions For Use
Note: before performing any wet floor service procedure set a safety perimeter using wet floor signs, cones, placards, and/or caution tape. Notify personnel in the facility that services are being performed.

Preparation
Ensure floor surface has been cleaned prior to applying
Infusion™ Penetrating Hardener.

Initial Maintenance
After initial cleaning, apply multiple coats of Fusion™ Floor Seal/Finish to establish desired appearance level, apply one (1) coat of Infusion™ Penetrating Hardener over entire floor area and burnish to high gloss.

Routine Maintenance
After performing standard dry soil removal and wet mopping or light scrubbing service procedures apply Infusion™ Penetrating Hardener to visible traffic lanes and burnish to high gloss. Note: for Routine maintenance Infusion™ Penetrating Hardener need only be applied in traffic lanes.

Periodic Maintenance
Machine scrub the designated floor area with rotary floor machine or automatic scrubbing machine in conjunction with appropriate pad and cleaning chemical for service procedure being performed.

Apply Fusion™ Floor Seal/Finish to replace worn floor product.
After finish has dried, apply one coat Infusion™ Penetrating Hardener and burnish to high gloss.

Note: for periodic maintenance Infusion™ Penetrating Hardener is applied over floor finish, however, it is not necessary to apply product over entire area, just enough to overlap the area where finish was applied.

Salvage/Restorative Maintenance
Remove all pre-existing coats of floor seal and/or finish using High Voltage™ Stripper mixed in accordance with manufacturers recommended dilution ratios. Once floor is dry perform initial maintenance application.

Technical Specifications
Click on link below to download a pdf document for complete Technical specifications and usage.

Download PDF
Download Infusion™ Floor Sealer & Finish [pdf - 1.83MB]

MSDS Documentation
Download Infusion Floor Sealer & Finish MSDS [doc - 54k]